docs: move the output log of targets to .inc files

docs/en/get-started/esp32s2_output_log.inc

@@ -0,0 +1,39 @@
+.. output_log
+
+.. code-block:: none
+
+    ...
+    esptool.py --chip esp32s2 -p /dev/ttyUSB0 -b 460800 --before=default_reset --after=hard_reset write_flash --flash_mode dio --flash_freq 40m --flash_size 2MB 0x8000 partition_table/partition-table.bin 0x1000 bootloader/bootloader.bin 0x10000 hello_world.bin
+    esptool.py v3.0-dev
+    Serial port /dev/ttyUSB0
+    Connecting....
+    Chip is ESP32-S2
+    Features: WiFi
+    Crystal is 40MHz
+    MAC: 18:fe:34:72:50:e3
+    Uploading stub...
+    Running stub...
+    Stub running...
+    Changing baud rate to 460800
+    Changed.
+    Configuring flash size...
+    Compressed 3072 bytes to 103...
+    Writing at 0x00008000... (100 %)
+    Wrote 3072 bytes (103 compressed) at 0x00008000 in 0.0 seconds (effective 3851.6 kbit/s)...
+    Hash of data verified.
+    Compressed 22592 bytes to 13483...
+    Writing at 0x00001000... (100 %)
+    Wrote 22592 bytes (13483 compressed) at 0x00001000 in 0.3 seconds (effective 595.1 kbit/s)...
+    Hash of data verified.
+    Compressed 140048 bytes to 70298...
+    Writing at 0x00010000... (20 %)
+    Writing at 0x00014000... (40 %)
+    Writing at 0x00018000... (60 %)
+    Writing at 0x0001c000... (80 %)
+    Writing at 0x00020000... (100 %)
+    Wrote 140048 bytes (70298 compressed) at 0x00010000 in 1.7 seconds (effective 662.5 kbit/s)...
+    Hash of data verified.
+
+    Leaving...
+    Hard resetting via RTS pin...
+    Done