docs: move the output log of targets to .inc files

docs/en/get-started/esp32s3_output_log.inc

@@ -0,0 +1,43 @@
+.. output_log
+
+.. code-block:: none
+
+    ...
+    esptool.py esp32s3 -p /dev/ttyUSB0 -b 460800 --before=default_reset --after=hard_reset write_flash --flash_mode dio --flash_freq 80m --flash_size 2MB 0x0 bootloader/bootloader.bin 0x10000 hello_world.bin 0x8000 partition_table/partition-table.bin
+    esptool.py v3.2-dev
+    Serial port /dev/ttyUSB0
+    Connecting....
+    Chip is ESP32-S3
+    Features: WiFi, BLE
+    Crystal is 40MHz
+    MAC: 7c:df:a1:e0:00:64
+    Uploading stub...
+    Running stub...
+    Stub running...
+    Changing baud rate to 460800
+    Changed.
+    Configuring flash size...
+    Flash will be erased from 0x00000000 to 0x00004fff...
+    Flash will be erased from 0x00010000 to 0x00039fff...
+    Flash will be erased from 0x00008000 to 0x00008fff...
+    Compressed 18896 bytes to 11758...
+    Writing at 0x00000000... (100 %)
+    Wrote 18896 bytes (11758 compressed) at 0x00000000 in 0.5 seconds (effective 279.9 kbit/s)...
+    Hash of data verified.
+    Compressed 168208 bytes to 88178...
+    Writing at 0x00010000... (16 %)
+    Writing at 0x0001a80f... (33 %)
+    Writing at 0x000201f1... (50 %)
+    Writing at 0x00025dcf... (66 %)
+    Writing at 0x0002d0be... (83 %)
+    Writing at 0x00036c07... (100 %)
+    Wrote 168208 bytes (88178 compressed) at 0x00010000 in 2.4 seconds (effective 569.2 kbit/s)...
+    Hash of data verified.
+    Compressed 3072 bytes to 103...
+    Writing at 0x00008000... (100 %)
+    Wrote 3072 bytes (103 compressed) at 0x00008000 in 0.1 seconds (effective 478.9 kbit/s)...
+    Hash of data verified.
+
+    Leaving...
+    Hard resetting via RTS pin...
+    Done