alex/esp-idf
1
0
Fork 0
mirror of https://github.com/espressif/esp-idf.git synced 2025-08-07 20:00:53 +00:00
Code Issues Packages Projects Releases Wiki Activity

examples: added support of ESP32-S3 chip in controller_hci_uart example

Browse Source
This commit is contained in:
wangmengyang
2021-08-26 14:24:32 +08:00
parent da12db2904
commit c053ef0541
5 changed files with 165 additions and 10 deletions
Download Patch File Download Diff File Expand all files Collapse all files

10
examples/bluetooth/hci/controller_hci_uart_esp32c3/README.md
View File

@@ -1,11 +1,11 @@
ESP-IDF UART HCI Controller
=================================
| Supported Targets | ESP32-C3 |
| ----------------- | -------- |
| Supported Targets | ESP32-C3 | ESP32-S3 |
| ----------------- | -------- | -------- |
This example demonstrates how to configure the Bluetooth Low Energy Controller's HCI (Host Controller Interface) to communicate over UART.
Using this example, BLE radio capabilities of ESP32-C3 chip, can be:
Using this example, BLE radio capabilities of ESP32-C3/ESP32-S3 chip, can be:
1. tested via standard HCI messages in Direct Test Mode
@@ -19,7 +19,7 @@ This example uses LL/register access directly, because the UHCI driver hasn't be
### Hardware Required
This example should be able to run on any commonly available ESP32-C3 development board. To connect UART to PC, another board such as ESP_Test Board or FT232 USB UART board is usually needed.
This example should be able to run on any commonly available ESP32-C3/ESP32-S3 development board. To connect UART to PC, another board such as ESP_Test Board or FT232 USB UART board is usually needed.
In this example, two UARTs are used:
@@ -30,7 +30,7 @@ In this example, two UARTs are used:
RTS and CTS lines of UART1 are required. GPIO4, GPIO5, GPIO6, GPIO7 are used as TxD, RxD, RTS, CTS PINs of UART1, respectively.
In a frequently-used scenario, if ESP_Test Board is used, connect the TX0, RX0, RTS0, CTS0 and GND of ESP_Test Board to ESP32-C3 UART1 PINs, and Attach ESP_Test board to the host PC.
In a frequently-used scenario, if ESP_Test Board is used, connect the TX0, RX0, RTS0, CTS0 and GND of ESP_Test Board to ESP32-C3/ESP32-S3 UART1 PINs, and Attach ESP_Test board to the host PC.
### Configure the project