This change addresses a rare but critical issue observed on certain
ESP32-C3 and ESP32-S3 devices, where secure boot verification
intermittently fails due to improper cleanup of crypto peripherals
during a restart.
Background – Restart Behavior in IDF
------------------------------------
In ESP-IDF, when the device restarts (via `esp_restart()` or due to a
panic/exception), a partial peripheral reset is performed followed by a
CPU reset. However, until now, crypto-related peripherals were not
included in this selective reset sequence.
Problem Scenario
----------------
If a restart occurs while the application is in the middle of a bignum
operation (i.e., using the MPI/Bignum peripheral), the ROM code may
encounter an inconsistent peripheral state during the subsequent boot.
This leads to transient RSA-PSS secure boot verification failures.
Following such a failure, the ROM typically triggers a full-chip reset
via the watchdog timer (WDT). This full reset clears the crypto
peripheral state, allowing secure boot verification to succeed on the
next boot.
Risk with Aggressive Revocation
-------------------------------
If secure boot aggressive revocation is enabled (disabled by default in
IDF), this transient verification failure could mistakenly lead to
revocation of the secure boot digest.
If your product configuration has aggressive revocation enabled,
applying this fix is strongly recommended.
Frequency of Occurrence
-----------------------
The issue is rare and only occurs in corner cases involving
simultaneous use of the MPI peripheral and an immediate CPU reset.
Fix
---
This fix ensures that all crypto peripherals are explicitly reset prior
to any software-triggered restart (including panic scenarios),
guaranteeing a clean peripheral state for the next boot and preventing
incorrect secure boot behavior.
feat: remove suppport for AES, RSA, DS and HMAC in esp32c61
Closes IDF-9326, IDF-9328, IDF-9323, and IDF-9325
See merge request espressif/esp-idf!31798
- Support SOC ROOT clock source switch
- Support CPU frequency change
- Support RTC SLOW clock source switch
- Support RTC SLOW clock + RC FAST calibration
- Remove FPGA build
