| Supported Targets | ESP32-C2 | ESP32-C3 | ESP32-C5 | ESP32-C6 | ESP32-C61 | ESP32-H2 | ESP32-P4 | ESP32-S2 | ESP32-S3 |
| ----------------- | -------- | -------- | -------- | -------- | --------- | -------- | -------- | -------- | -------- |

# Temperature Sensor Example

The ESP32-S2/C3/S3/C2 has a built-in temperature sensor. The temperature sensor module contains an 8-bit Sigma-Delta ADC and a temperature offset DAC.

The conversion relationship is the first two columns of the table below. Among them, `offset = 0`(default) is the main measurement option, and other values are extended measurement options.

| DAC level | offset | measure range(℃) |
| :-------: | :----: | :--------------: |
|     0     |   -2   |     50 ~ 125     |
|     1     |   -1   |     20 ~ 100     |
|     2     |   0    |     -10 ~ 80     |
|     3     |   1    |     -30 ~ 50     |
|     4     |   2    |     -40 ~ 20     |

> **Note**: The temperature sensor is integrated directly into the chip. The sensor is designed primarily to measure the internal temperature of the chip, and its readings can be affected by factors such as the microcontroller's clock frequency, I/O load, and the external environment. 

## How to use example

Before project configuration and build, be sure to set the correct chip target using `idf.py set-target <chip_name>`.

### Hardware Required

* A development board with ESP32-S2/C3/S3/C2 SoC (e.g., ESP32-S2-Saola-1, ESP32-S2-DevKitM-1, ESP32-C3-DevKitM-1, ESP32-S3-WROOM-1, etc.)
* A USB cable for power supply and programming

### Build and Flash

Build the project and flash it to the board, then run monitor tool to view serial output:

Run `idf.py -p PORT flash monitor` to build, flash and monitor the project.

(To exit the serial monitor, type ``Ctrl-]``.)

See the [Getting Started Guide](https://docs.espressif.com/projects/esp-idf/en/latest/esp32s2/get-started/index.html) for full steps to configure and use ESP-IDF to build projects.

## Example Output

```
I (0) cpu_start: Starting scheduler on APP CPU.
I (303) example: Install temperature sensor, expected temp ranger range: 10~50 ℃
I (303) temperature_sensor: Range [-10°C ~ 80°C], error < 1°C
I (313) example: Enable temperature sensor
I (323) example: Read temperature
I (323) example: Temperature value 26.06 ℃
I (1323) example: Temperature value 26.06 ℃
I (2323) example: Temperature value 26.06 ℃
I (3323) example: Temperature value 26.06 ℃
I (4323) example: Temperature value 26.06 ℃
I (5323) example: Temperature value 26.49 ℃

```

## Troubleshooting

For any technical queries, please open an [issue](https://github.com/espressif/esp-idf/issues) on GitHub. We will get back to you soon.