mirror of
https://github.com/espressif/esp-idf.git
synced 2025-08-08 20:21:04 +00:00
1c92945f59
Currently, several example dependencies rely on the fact that all registered components are added to the build, along with components specified in common requirements. This results in longer build times because even unused components must be built. Switch all examples to use idf_minimal_build to compile only the components actually required by the example. Signed-off-by: Frantisek Hrbata <frantisek.hrbata@espressif.com>
| Supported Targets | ESP32-S2 | ESP32-S3 |
|---|
ULP-RISC-V ADC Example
This example demonstrates how to use the ULP-RISC-V coprocessor to poll the ADC in deep sleep.
The ULP program periodically measures the input voltage on EXAMPLE_ADC_CHANNEL (by default ADC1 channel 0, GPIO1 on both ESP32-S2 and ESP32-S3). The voltage is compared to an upper threshold. If the voltage is higher than the threshold, the ULP wakes up the system.
By default, the threshold is set to 1.75V, approximately.
In this example, you need to connect a voltage source (e.g. a DC power supply) to the GPIO pin corresponding to the ADC channel specified in ulp/example_config.h (see the macros defined on the top of the header file). Feel free to modify the channel setting.
Hardware Required
- A development board with a SOC which has a RISC-V ULP coprocessor (e.g., ESP32-S2 Saola)
- A USB cable for power supply and programming
Example output
Below is the output from this example.
Not a ULP-RISC-V wakeup (cause = 0), initializing it!
Entering in deep sleep
ULP-RISC-V woke up the main CPU
Threshold: high = 2000
Value = 4095 was above threshold
Entering in deep sleep