mirror of
https://github.com/espressif/esp-rainmaker.git
synced 2026-01-15 10:25:28 +00:00
f4767018f9
The common code for WS2812 RGB LED has been moved to a component ws2812_led. The WS2812 LED is available only on ESP32-S2-Saola-1 boards and hence it will be enabled only if IDF target is set to ESP32S2. It can be disabled by disabling the CONFIG_WS2812_LED_ENABLE config option. led_strip component files have also been moved to ws2812_led
Switch Example
Build and Flash firmware
Follow the ESP RainMaker Documentation Get Started section to build and flash this firmware. Just note the path of this example.
What to expect in this example?
- This example uses the BOOT button and RGB LED on the ESP32-S2-Saola-1 board to demonstrate a switch.
- The LED state (green color) indicates the state of the switch.
- Pressing the BOOT button will toggle the state of the switch and hence the LED. This will also reflect on the phone app.
- Toggling the button on the phone app should toggle the LED on your board, and also print messages like these on the ESP32-S2 monitor:
I (16073) app_main: Received value = true for Switch - power
LED not working?
The ESP32-S2-Saola-1 board has the RGB LED connected to GPIO 18. However, a few earlier boards may have it on GPIO 17. Please use CONFIG_WS2812_LED_GPIO to set the appropriate value.
Reset to Factory
Press and hold the BOOT button for more than 3 seconds to reset the board to factory defaults. You will have to provision the board again to use it.