mirror of
https://github.com/espressif/esp-rainmaker.git
synced 2026-01-15 08:19:59 +00:00
86b4dbbd68
And some other minor changes - Corrected comments in example READMEs and sdkconfig.defaults - Duplicate macro in homekit_switch removed
24 lines
1.2 KiB
Markdown
24 lines
1.2 KiB
Markdown
# Temperature Sensor Example
|
|
|
|
## Build and Flash firmware
|
|
|
|
Follow the ESP RainMaker Documentation [Get Started](https://rainmaker.espressif.com/docs/get-started.html) section to build and flash this firmware. Just note the path of this example.
|
|
|
|
## What to expect in this example?
|
|
|
|
- This example uses esp timer and the RGB LED on the ESP32-S2-Saola-1/ESP32-C3-DevKitC board to demonstrate a temperature sensor.
|
|
- The temperature value is changed by 0.5 every minute.
|
|
- It starts at some default value (25.0) and goes on increasing till 99.5. Then it starts reducing till it comes to 0.5. The cycle keeps repeating.
|
|
- The LED color indicates the temperature.
|
|
- LED hue changes from 200 (bluish) to 0 (reddish) as the temperature increases from 0.5 to 99.5.
|
|
- You can check the temperature changes in the phone app.
|
|
|
|
### LED not working?
|
|
|
|
The ESP32-S2-Saola-1 board has the RGB LED connected to GPIO 18. However, a few earlier boards may have it on GPIO 17. Please use `CONFIG_WS2812_LED_GPIO` to set the appropriate value.
|
|
|
|
### Reset to Factory
|
|
|
|
Press and hold the BOOT button for more than 3 seconds to reset the board to factory defaults. You will have to provision the board again to use it.
|
|
|